It’s a time indicator for when the cartridge is running low and needs replacing. It will go from 4 bars to 3 to 2 to 1 and then needs replacing.
Simply press the button to start the countdown. It automatically reminds you when it’s time to replace the water filter. BRITA METER uses three factors to determine the optimum time to replace your filter: the volume of water filtered, the water hardness and the time since the water filter was last replaced.
How do I know if my Brita filter is working?
Check filter life status at any time by pressing STATUS button for 1 second. Light will flash green, yellow or red depending on filter life remaining. The light will also blink after water is poured from the pitcher. A blinking green light indicates that the filter is good.
How does the Brita LED indicator work?
Using an intelligent mechanism the volume is recorded by registering the amount of water flowing out, when the jug is tilted during usage. … Just after pouring water, the LED blinks to show the cartridge status. Additionally the cartridge status can be checked any time by simply pressing the LED button.
How often should I wash my Brita water jug?
Discard the filter (you should be doing this every two to six months, anyway). Wash the pieces: Scrub the lid and reservoir with dish soap and warm water. Attack the mildew: If you still have mildewy bits, make a mixture of one teaspoon white vinegar to one cup of water.
Why is my Brita filtering so fast?
When the filter is not attached to the locking system correctly, it will create a gap between the filter and the container. The space between the filter and the container will leak the water, and you will notice the water is dropping very fast.
Why is my Brita filter not working?
Brita filters may be slow because of aeration from your tap water, bubbles trapped in the filter, high sediment levels, faulty installation, low water pressure (for Brita faucet filters), or an old filter. There are 9 specific reasons why your Brita filter could be too slow.
How do you reset a Brita filter indicator on a tap?
To reset the indicator, press the STATUS button and hold it down. If using a Standard Filter (white in color), hold down the STATUS button for 2 seconds, then release. All lights will blink simultaneously twice, then the green light next to STANDARD FILTER will blink three times.
Should Brita filter be refrigerated?
Most manufacturers do recommend refrigeration, though not always with an emphasis on health and safety. “We recommend that you store your Brita system in the refrigerator to get cold, great-tasting water,” reads the manual for the Brita Smart Pitcher OB39/42632, a top performer in our latest water filter review.
How many times can you use a Brita filter?
The Brita Standard Filter (white) should be replaced after every 40 gallons, or about every two months. The Brita Longlast Filter (blue) needs to be replaced after every 120 gallons, or approximately every six months.
How do I know if my water filter is working?
How to Tell if Your Water Filter Is Working
- A slow decrease in water pressure. …
- Checked the outside of the filter. …
- Drains or faucets start to make odd noises. …
- Turbidity or bad tasting water.
What does orange light on Brita filter mean?
Keep an eye out on the Smart Light on the lid of your Style Jug – the traffic light system is an easy reminder – green is ideal; orange means it’s not at the optimal performance and red means you should change as soon as you can!
How do I reset my Brita led?
To reset, remove the BRITA Cartridge Status Indicator from the lever. Push both buttons of the BRITA Cartridge Status Indicator at the same time for three seconds until the colored LED light flashes green, yellow and red. Make sure you push both buttons at the same time.
Why is my Brita filter not turning green?
The indicator light on a Brita faucet filter may stop working after 2-5 years because the non-replaceable sealed battery has run out. If your facet filter is still within its one-year warranty, contact Brita support so it can be repaired or replaced.