The filter usually fits in a slot on the air return side of the unit. These systems are usually found in smaller basements or crawl spaces where space is limited. The filter typically slides into a slot above or below the HVAC unit.
Where is my air filter located in my house?
Behind a register in the floor (in older homes). On the HVAC unit near the air handler, which looks a bit like a furnace. Look for your air handler in the basement or the attic. The air filter slots into the air handler unit.
How many filters does a HVAC have?
How Many Air Filters Does a House Have? Typically, a house will have 2 air filters in their intake vents. In some cases, there can be more or fewer depending on the square footage of the home or apartment and the number of floors that need to be supported by the central air system.
Is the furnace filter the same as the AC filter?
While many people refer to air conditioning and furnace filters as if they’re different, this is not the case. Your furnace and your air conditioning system use the exact same filter, so there’s no need to worry about purchasing separate filters for each piece of equipment.
Do HVAC systems have filters?
All central heating and cooling systems should have an air filter, but the filter can be harder to locate on some HVAC units than others. The air filter is usually located in the return air duct or blower compartment before the return air reaches the air handler.
What happens if you use AC without filter?
Without a filter, the condensation drain will fail to drain the moisture from your AC unit. This will result in condensation accumulation on the Freon tubing. The condensation will then start dripping down the pan, causing water damage to the whole system.
Do all HVAC returns have filters?
If there is no air filter at your HVAC unit, then you absolutely need a return vent filter. We recommend using a MERV-5 to MERV-8 pleated air filter in your return vent. … So it will serve as the only line of defense against dust and particles entering your HVAC system.
How often should you change HVAC filter?
Here are averages that may help you know how regularly you should get a new air filter at your residence: Vacation house or one occupant and no pets or allergies: every 6–12 months. Ordinary suburban home without pets: every 90 days. One dog or cat: every 60 days.
How much does it cost to replace HVAC filter?
However, in some cases, the professional will charge by the service. For example, a typical dirty air filter repair costs about $50 for a house call fee plus the cost to replace the air filter. A routine maintenance call will cost an average of $120.
Can I change my own air filter?
You may not be ready to tackle car maintenance jobs like changing the oil or replacing spark plugs, but changing your vehicle’s engine air filter is an easy job that you can do. Doing this job yourself can result in big savings. Many quick lube shops charge up to $25 or more to change an air filter.
Can I replace furnace filter myself?
To Change Your Home Air Filter, You’ll Need To Turn Off Your Furnace. To prevent the HVAC unit from turning on while you are changing the filter, make sure you turn the thermostat to the “off” position. This will help protect your HVAC system from loose debris or maybe a loose filter fitting escaping into the duct.
How do I know if my furnace has a filter?
Your furnace filter will most likely be found in the blower of your furnace.
Where Is My Furnace Filter?
- Horizontal HVAC unit – Furnace filter will be located on the intake side, slid into a rack.
- Vertical HVAC unit with air moving upwards – You can find your furnace filter in the bottom door.
Why is my heat blowing cold air?
A clogged filter is one of the leading reasons for a heater blowing cold air. But even if you swap the air filter with a brand new one, dirt and debris can still be found within the unit. This could eventually lead to overheating. If your furnace looks pretty dirty, call an HVAC provider for a professional clean.
What filter should I use for HVAC?
HEPA filters remove a majority of particles down to 0.3 microns in size. This fine level of filtering provides more resistance to airflow, which can put strain on a residential HVAC system.