Why won’t my GE fridge dispense water after replacing filter?

If your GE refrigerator won’t dispense water after the filter has been replaced, it could be that the water supply tube in the door is frozen. … If air is not able to pass through the tube, it is frozen and will need to be thawed out, which can be done by simply leaving it at room temperature for about an hour.

Why is there no water coming out of my GE refrigerator?

Filter Issues: On models with a water filter, a clogged or partially clogged filter will result in no water or slow running water from the refrigerator dispenser. Please change the filter. … Try using the dispenser and if the water flow improves from the dispenser, the filter is clogged and needs to be replaced.

How do you reset a GE refrigerator water dispenser?

Press and hold the dispensers lock and auto light buttons at the same time until the filter status indicator starts to flash.

IMPORTANT:  Is 40 micron fuel filter good?

How do I reset my GE refrigerator after changing the water filter?

After you change the water filter, the RESET WATER FILTER button must be pressed and held down for 3 seconds until the red light goes off. On some models the light goes out and on others it will turn green; either is considered normal. If you do not hold the button down firmly, the red light will stay on.

Why is my water filter not dispensing water?

The failure of a water dispenser to dispense water is usually caused by one of the following conditions: You have air in your water line. Your refrigerator water line is not turned on. Your water filter cartridge needs to be replaced.

Why is my water dispenser not working on my refrigerator?

Check to see if the tube bringing water in has a little debris screen on it, which may have gotten clogged. If so, clean the screen to allow water back into the water dispenser. Check the inlet tubing for blockage, and make sure the manual water shut-off valve is clean and clear on the inside.

Why is my refrigerator not dispensing water?

Often times, the water dispenser in your fridge may have stopped working due to a frozen water supply tube. This is a common problem in side-by-side refrigerators in which the tube that connects your water supply to the door where the water dispenser is frozen due to improper temperatures.

How do you reset a refrigerator after changing filter?

To reset the water filter indicator you need to find the multi-function button(s) on your display that controls the filter indicator. Then press and hold the button(s) until the light changes.

IMPORTANT:  Question: What is the difference between a HEPA vacuum and regular vacuum?

Does GE refrigerator have a reset button?

General Electric (GE) refrigerators do not have a dedicated reset button, but in the event of a technical issue, you can reset your refrigerator. There are a lot of people who also face difficulty while unlocking the GE refrigerator control panel.

Will GE refrigerator dispense water without a filter?

Your GE refrigerator will not make ice or dispense water if there is no filter or if the filter needs to be replaced. You can install a filter bypass plug to keep the water flowing in your refrigerator or when your home is equipped with a reverse osmosis water-treatment system.

How do I reset my GE French door refrigerator?

Try resetting the control panel by turning off power to the refrigerator briefly. Unplug the refrigerator or turn it off at the circuit breaker for 30 seconds to reset the control.

What does Reset water filter mean?

After changing the water filter, reset the status. Press and hold the “WATER FILTER” button for 3 seconds. When the system is reset, the water filter icon will return to its BLUE color and the words “Replace Filter” will disappear from the display.

Why is my GE refrigerator not dispensing water or ice?

If you discover your GE refrigerator not dispensing water or ice, the dispenser switch may have failed. No voltage, no working dispenser. A multimeter can be used to check for continuity to determine if the dispenser switch is working properly. If there is no continuity, then the switch needs to be replaced.